Multiple Threshold (Multi Vt) Cell Libraries

With the technologies shrinking to 90nm, 30nm and below one of the
common ways to reduce leakage power is to use multiple Vt libraries.
Subthreshold leakage varies exponentially with the Vt comparated to
the weaker dependance of delay over Vt.


Libraries are offered in different versions each consisting of
standard Vt cells, low Vt cells and high Vt cells independant of each
other. Power and timing is optimized based on these libraries and they
offer good flexibility and opportunity to logic and physical synthesis
tool for optimization process.


Dual Vt synthesis flow has become quite common in 130nm and below
tehnology nodes. In this flow initial synthesis is carried out
targeting primary library which may be a low Vt or high Vt or normal
Vt library, and the second iteraton of synthesis and optimization is
performed based on secondary libraries which are also libraries
consistitng of multiple threshold cells.


Which library has to be used as primary library ?


This depends on the optimization target as per the design requirement.
In general, if optimization target is power performance, first
syntheize the design using the high Vt cell library which achieves
lowest leakage power. In the next iteration of optimization cells in
the critical path has to be replaced by low Vt cells which are faster.
If the optimization target is to meet timing then first use low Vt
cell library to achieve timing and then optimize leakage power using
high Vt cells.

9 comments:

  1. My question is wherein lies the difference between lvt ,hvt,rvt
    the size or the construction or the material ???

    ReplyDelete
  2. Main difference between these cells are threshold voltages. Different threshold voltages are achieved by implanting dopants in different concentration.

    ReplyDelete
  3. std logic cell in lvt and hvt libraries have same hight or different hight?

    ReplyDelete
  4. This comment has been removed by the author.

    ReplyDelete
  5. lvt , hvt cells having same width and height ,i.e same area . they different in doping concentration ...

    ReplyDelete
  6. How does dynamic power vary if one design use all lvt cells and same design use all hvt cells?

    ReplyDelete
  7. @jack, The threshold(t) voltage dictates the transistor switching speed , it matters how much minimum threshold voltage applied can make the transistor switching to active state which results to how fast we can switch the transistor

    ReplyDelete
  8. How to use lvt cells on the critical path and hvt cells on the remaining parts of the circuit in 90nm? Is there some reference manual for this?

    ReplyDelete
  9. How can we use lvt cells on the critical path and hvt cells on the remaining circuit in a 90nm? Is there a manual to do so?

    ReplyDelete

Your Comments... (comments are moderated)